Universal Smart-Sensor
Reads third-party equipment
Translates an analogue signal from third-party equipment into a measurement in OCEAView. Used for particle counters, oxygen monitors, cooling systems and cell production equipment.
What is the Universal Smart-Sensor, and how does it work?
Most laboratory and process instruments can output an analogue signal that represents their measured value. The Universal Smart-Sensor reads that signal and turns it into a measuring point on a par with temperature and humidity, with its own limits, its own delay and its own place in the report.
It supports 4-20 mA, 0-5 V and 0-10 V. The advantage of 4-20 mA is that 4 milliamps corresponds to the bottom of the measuring range and 20 to the top. If the signal drops to 0, it means a broken cable rather than a low reading, so a lost connection can be told apart from a genuine drop.
Specifications
Signal types
4-20 mA, 0-5 V, 0-10 V
Function
Converts to a measuring point
Connects to
Cobalt X and Cobalt XS
Limits
Own limits and delay
Network on the equipment
Not required
Report
Included in the same report
Full specifications and the data sheet are sent with the quote.
The product in use
The sensor connects directly to the equipment's analogue output. The equipment does not need to be on the network itself, because the signal is passed on via the data logger.
The third-party equipment then sits in the same dashboard as everything else and triggers the same escalation on deviation.
How to get it
We do not sell individual parts over the counter. We put the setup together based on what we see at your site and take care of the rest.
Request a quote
Tell us what you want to monitor. We will come back with questions or a proposal.
Walkthrough
We visit, look at your equipment and premises and advise on the number and placement of sensors.
Installation
We install, set up limits and on-call rotas and train your staff on the system.
Operation and calibration
We look after it afterwards. Calibration on time and sensor exchange without downtime.
Validation
We validate the system, on our own or together with your QA, and deliver the documentation.
Frequently asked questions
How do we know whether our equipment can be connected?
It is in the data sheet under outputs. If it can send 4-20 mA, 0-5 V or 0-10 V, it can be read. We check this during the walkthrough.
Does it replace the equipment's own alarm?
No. That stays in place. The system makes sure the alarm also reaches people outside the room and that the readings are stored.
Can we see it in the same graph as the temperature?
Yes. It is treated like any other measuring point.
Related products
The equipment can be combined freely. We put the setup together based on what needs to be measured at your site.
Kom hurtigt i kontakt med den rette specialist.
Vi hjælper med alt fra nye monitoreringsløsninger til kalibrering, validering og teknisk support.
Generelle henvendelser
Nye projekter
IT & teknik
Administration
Besøg os
Måløv Byvej 229
2760 Måløv
Ring til os
+45 72 22 02 05
Man-fre, 08-16
Fortæl os, hvad du har brug for.
Vil du se, hvordan det ser ud hos jer?
Book en gennemgang. Vi kommer forbi, ser på udstyr og lokaler og rådgiver om, hvor følerne skal sidde. Derefter får du et skræddersyet forslag. Uden forpligtelser.
Book en gennemgang